Follett 110 Series User Manual download pdf (Page 8)

Installing countertop dispensers

1. Position dispenser in desired location, mark

dispenser outline on counter and remove dispenser.

2. Drill four 5mm (3/8") holes in counter (Fig. 2) to

anchor dispenser to counter.

Follett countertop dispensers can have any or all

utilities run directly through counter or out rear of

dispenser. For dispensers with any utilities exiting

through counter, make counter cut-out as shown

in Fig. 2.

3. If ice transport tube will exit out rear of dispenser,

remove ice transport tube knock-out (Fig. 5G) from

rear of dispenser.

Note: Utility connections can be accessed through

front of dispenser by removing stainless steel splash

panel on front of dispenser, or by removing access

panel (Figs. 4, 5) on back of dispenser.

4. If any electric utilities or water line will be connected

through rear of dispenser, remove utility knock-out

(Fig. 5H) from rear of dispenser and install supplied

protective grommet.

5. If power is to be supplied through counter cut-out,

complete steps 6-9. If power is to be supplied through

rear of dispenser, proceed to step 10.

6. Temporarily remove rear access panel (Figs. 4, 5)

from rear of dispenser.

7. Loosen junction box mounting screws. Lift junction

box and power cord up until cord and mounting

screws clear notches on rear panel of dispenser.

Remove Phillips head screws from right side of

junction box.

8. Rotate junction box 90 degrees so that screw holes

on right side of junction box align with holes on rear

dispenser panel. Resecure junction box to dispenser

using Phillips head screws.

9. Place power cord inside dispenser and replace

access panel (Figs. 4 and 5) on rear of dispenser.

Note: For dispensers installed with utilities connected

through rear of dispenser, it may be easier to make

preliminary connections before dispenser is set in

place.

622mm

603mm

167mm

441mm

543mm

3/8"

311mm

13mm (.5")

41mm (1.625")

13mm (.5")

227mm x 356mm (9" X 14")

DRAIN PAN

CUT OUT

(21.375")

(6.54")

(17.375")

(24.5")

(23.75")

(12.25")

Fig. 2 – Counter cut-out, all models

(J) 3/8" FPT

water inlet

(L) alternate 3/4"

dispenser drain

location

drain pan

(K) 3/4" FPT

dispenser drain

Dispensers with top mount icemakers cannot be mounted on legs. They must be bolted to counter.

Use gloves when lifting icemaker to protect hands from sheet metal edges.

Fig. 3 – Top view, dispenser plumbing connections

countertop and wall mount units with drain pan

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Follett 110 Series User Manual Page 8

Comments to this Manuals

Related products and manuals for Ice cube makers Follett 110 Series