Follett 110 Series User Manual download pdf (Page 9)

10. Apply a thick bead, approximately. 6mm (1/4")

diameter, of NSF listed silicone sealant (Dow-

Corning RTV-732 or equivalent) 6mm (1/4") inside

marked outline of dispenser.

11. Carefully position dispenser on counter.

12. Remove four screws securing splash panel to front

of dispenser and gently lay splash panel on counter.

(Water line to solenoid valve can be disconnected

from water inlet valve by pushing on ring at end of

inlet fitting while pulling on tubing.)

13. Secure dispenser to counter with four 3/8" bolts

(supplied by others).

14. Smooth excess sealant around outside of dispenser.

15. Run water supply line from back of dispenser

through utility knock-out (Figs. 4, 5) or up through

counter cut-out. Connect water supply line to 3/8"

FPT, (Fig. 3J) fitting on utility flange at bottom of

dispenser.

16. Remove 3/4" drain connection plug from either fitting

at rear of dispenser, (Fig. 1K) or internal fitting, (Fig.

3L), as appropriate. Connect and run a dedicated

drain line to wall or floor drain. An air break should

be provided.

If dispenser is equipped with a top mount, water-

cooled icemaker complete steps 17 through 20.

If equipped with a top mount,

air-cooled icemaker proceed to step 21.

17. Connect icemaker water supply line to 3/8" FPT

water inlet, (Fig. 4M).

18. Connect icemaker drain line to 3/4 MPT drain

connection (Fig, 4N).

19. If icemaker is water-cooled, connect water-cooled

condenser supply line to 3/8" FPT condenser fitting

on back of dispenser (Fig. 4R).

Note: Do not run condenser supply water through

icemaker water filter system.

20. Connect condenser drain line to 3/8" FPT fitting on

back of dispenser (Fig. 4P).

Important: Do not connect condenser drain line to

any other drain lines.

21. Proceed with either Satellite-fill or top-mounted

icemaker connection instructions, as appropriate.

Fig. 4 – Rear connections, countertop models with

integral icemakers

Fig. 5 – Rear connections, countertop models with

Satellite-fill icemakers

access panel

(M) 3/8" FPT

icemaker water inlet

(R) 3/8" FPT condenser inlet

(water-cooled only)

(P) 3/8" FPT

condenser outlet

(water-cooled only)

(N) 3/4" MPT

icemaker drain

(H) utility knock-out

(G) ice transport tube knock-out

(H) utility knock-out

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Follett 110 Series User Manual Page 9

Comments to this Manuals

Related products and manuals for Ice cube makers Follett 110 Series