Follett 110 Series User Manual download pdf (Page 11)

1. Remove dispenser top front cover by removing two screws at bottom corners of cover, lifting cover slightly and pulling

forward.

2. Remove icemaker compartment top and side panels.

3. Remove icemaker hold-down bracket from front of icemaker compartment.

4. Lift icemaker onto dispenser top and slide icemaker completely into position, compressor end first. Front of icemaker

base must be flush with front of dispenser.

5. Reinstall hold down bracket on front of icemaker with power cord and bin signal cords in notch. Do not cut or pinch

cords.

6. Insert loose end of ice transport tube through bracket (on icemaker base) into hopper access hole. Be sure that transport

tube is secured under retainer on float reservoir bracket (Step 2, Fig. 7). Tighten transport tube clamp screw to secure ice

transport tube.

7. Connect plastic water supply line to fitting at top of float reservoir.

8. Connect vinyl drain line from dispenser securely to drain line on icemaker.

9. Connect icemaker two-lead bin signal twist lock plug, and three-lead power twist-lock plug, to dispenser twist-lock

connectors.

10. On dispensers equipped with water-cooled icemakers, connect condenser water supply and drain lines to condenser

fittings on icemaker.

11. Turn on water supply and check that water level in float reservoir (when full) is within 1/4" (6mm) of mark on side of

reservoir and that float moves freely.

12. Verify that water sensor tabs are immersed in water in reservoir. Check for leaks. Replace splash panel.

13. Install appropriate plug on power cord and insert into wall socket.

14. If dispenser is equipped with SensorSAFE remove protective plastic coating form dispense sensor labels.

15. Clean and sanitize icemaker following instructions in icemaker manual.

16. Remove dispenser hopper access lid and clean and sanitize dispenser according to instructions on page 14.

17. Replace front cover and secure with screws. Installation is complete.

Fig. 8 – Ice transport tube and ice level control stat mounting for units with top-mounted icemakers

TIGHTEN

CLAMP

SCREW

Fig. 7 – Ice transport tube

ice level control stat

45°

Hand bend cap tube

end to approximately.

45° as shown

19mm

(.75")

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Follett 110 Series User Manual Page 11