Follett 110 Series User Manual download pdf (Page 19)

Ice transport tube replacement

Models C/E110FB400A/W, C/E110CR400A/W

1. Remove top and rear access panel from dispenser (lower front panel in

freestanding unit).

2. Disconnect existing ice tube from engaging pin on transport tube bracket in ice

storage bin evaporator and pull down through dispenser chase.

3. Disconnect opposite end of tube from icemaker.

4. Run end of new ice transport tube with 5mm (3/16") hole through ice transport

tube knock-out, (Fig. 5G) in back of dispenser or through counter into bottom of

dispenser, being careful to avoid any bends with less than 153mm (6") radius.

5. Insert tube in internal chase in rear inside corner of dispenser (left side as you

face dispenser) and push up into storage area.

6. Push the 5mm (3/16") hole near end of tube into pin on ice tube bracket

(see drawing below).

Steps 7-8 for units with Satellite-fill icemakers only

7. Install supplied insulation to run of transport tube required for your site, leaving

approximately 51mm (2") of tube exposed at free end.

8. Check that insulated tube runs continuously uphill to dispenser with no dips.

Correct installation of ice transport tube is critical to Satellite-fill icemaker performance. Replacement

ice transport tubes for Satellite-fill icemakers must be insulated and run continuously from icemaker

to dispenser with no dips or bends with a radius of less than 153mm (6").

26mm

(1")

Section A – A

5mm (3/16")

dia. hole

Ice transport tube replacement

Top mount ice machines, model C/E110CT400A/W

Only use tubing supplied by Follett Corporation.

TIGHTEN

CLAMP

SCREW

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Follett 110 Series User Manual Page 19